...
...
...
...
| |||||||||||
| Messages you should not normally see | |||||||||||
| File not found | File not saved properly | ||||||||||
| Last file failed | File in Use | ||||||||||
| ABOUT | Disclaimer | ||||||||||
| FAQ | |||||||||||
| Design and contact details |
...
Theirry's introduction read
Thanks for purchasing the 1M (1024K) or the NEW 512K RAM/Flash card.
Now, you will have a lot of room to save your files.
The Z88 erases the Flash card, you no longer need an EPROM Eraser.
FAST ERASING - takes less than ten seconds to erase 1024K bytes.
FAST SAVING - takes three seconds to save a 20K file.
LOW POWER - takes a tenth of the power used by a standard EPROM.
| Anchor | ||||
|---|---|---|---|---|
|
...
| Anchor | ||||
|---|---|---|---|---|
|
- Do I need to format the EPROM Flash Card before I can start saving files to it?
No. You will notice that there are some files that have been included on the Flash EPROM Card that you may find useful. One of these files is this User Guide. Use the Catalogue files to see what there is. - Does the format only wipe out the text files? i.e. does formatting leave the 64K of applications untouched?
Only the file area File Area is formatted. Applications remain on the Flash card. - When I FETCH something from the Flash card, where am I fetching it to?
To the default RAM device as set on the Panel []S or to the Default RAM device set by this application.
- Is this the same as loading a file into Pipedream? i.e. I can FETCH my documents from the EPROM?
You need to use the RAM device as an intermediate device when either fetching or saving files. - Can I EXPORT files from the EPROM directly to my PC or do I have to load them into :RAM.0 or :RAM.1 first?
Yes, but only if you are using OZ 4.3 or Eazylink v5.1. Contact Rakewell for upgrade details.
Return to menu
...