...
Setup Mode B is implemented with the following features:
| Default | Options |
---|---|---|
Auto Repeat | Yes | No |
AutoXONAuto XON/XOFF | Yes | No - set from Z88 Panel |
Bits/char | 7 | 8 |
Cursor | Block | Permanently set |
Margin Bell | No | Permanently reset |
New Line | No | Yes |
Parity | None | Odd, Even, Space, Mark |
Rx speed | 9600 | set from Z88 Panel |
Tx speed | 9600 | set from Z88 Panel |
Wraparound | Yes | No |
Shift 3 | # | £ |
To alter the setting of any of the features, move the cursor onto the feature and press the -ENTER- key. Vision/L will cycle through an the available options for the feature.
...
Setup mode Z provides the following features:
Default | Options | Options | |
---|---|---|---|
Break time | 30 | 10 to 255 | |
Local echo | Yes | No | |
Tx file echo | Yes | No | |
Move window | Yes | No | |
Tx file add LF | No | Yes | |
Cursor blink | Yes | Permanently set |
...
To access a PF key, press the 0 key to bring up the function key display. Then, press the '-TAB-' key. Note that the legend above numeric keys 1-4 changes to PF 1-4'. The required PF key can then be obtained by simply pressing the designated number key.
Note that the PF key display shows additional function keys for VT220 and VT320 terminals. These keys are not available in the VTl00 VT100 terminal and are not implemented in Vision/L. Codes are only transmitted for the PF keys and '-ESC-', 13S, and 'LF'. All other keys are ignored. Users requiring the full range of function keys should refer to the Ranger Vision-100 package, which is available separately.
...
Note that the operation of the □ key is subtly different from the operation of the CTRL key on a VT100 terminal or PC. When the □ key is pressed on Vision/L, the condition is held and a square appears at the extreme right-hand side of the screen. The condition is then cleared by pressing any character key or the □ key again. This facilitates hand-held operation of Vision/L.
Application Program | Key used with the □ key |
---|---|
Diary | D |
PipeDream | P |
BASIC | B |
Calculator | R |
Calendar | C |
Clock | T |
Alarm | A |
Filer | F |
PrinterEd | E |
Panel | S |
Terminal | V |
Imp-Export | X |
Vision/L | ZV |
...