Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 31 Next »

This section describes all of the PipeDream commands that are available in each menu. To understand this chapter, you should already be familiar with the basic concepts of using PipeDream described in Section Two - Using PipeDream.

All commands can be typed directly from the keyboard, as well as chosen from the appropriate menu. The keyboard equivalent for each command is shown to the right of the command name in the menu. For example, the Replicate command on the BLOCKS menu appears as

Replicate BRE

This means that you can give the Replicate command by typing the  key followed by the keys B R E. Note that the letters do not need to be in capitals:  b r e has the same effect. Also, you can hold down the  key while typing the letter keys if you prefer.

When, as in this example, the command equivalent is a sequence of two or three letters, the first letter will usually be the first letter of the menu name. For frequently-used commands, the key equivalent is a single letter with the  key (in a very few cases the  key). For example, the Mark Block command on the BLOCKS menu has the equivalent Z.

Note that in the following screen diagrams the highlighting bar has been omitted for clarity.

Setting the options

Some commands present you with a table of options which allow you to set up the command to your requirements.

To begin with, the cursor is positioned next to the first option; the cursor keys can be' used as normal to move up and down the list.

Many of the options have only two possible alternatives: Yes and No. You can change the value shown either by typing Y or N as appropriate, or by using the Next Option command, J, which alternates between the available values. In the case of options which take specific values, such as Page Length, Next Option restores the default value.

 

 

 

 

  • No labels