Send Files to Z88 from Client
- Gunther Strube
EazyLink Server, V4.4
Request for sending Files to Z88 from Client as specified in the command header. Please note that wildcards may not be used, only exact filenames.
Any path specified in the filename is automatically created by the EazyLink Server when the file is being created on the Z88 (successfully receiving the filename).
The request command allows for several files to be sent during the same command session.
Please note that the current translation status reflects the data sent to Z88. Activating the []L popdown, the default translation is NONE with no line feed conversion, ie. every byte sent the Z88 is unaffected. This is the original state of the PC-LINK II Server popdown.
If you chose to activate one of the translation/conversion commands, every byte sent the Z88 is translated using either the internal ISO/IBM Codepage 865 or an external "translate.dat" translation table.
The translation and line feed conversion status may also have been enabled or disabled using the appropriate request commands (see later). However, this may only be possible using the EazyLink extended protocol (the original PC-LINK II client doesn't support translation nor line feed conversion during transfer using the EazyLink interface).
------------------------------------------------------------------------------
Client Server Action
------------------------------------------------------------------------------
<ESC "S"> -> waiting... Send files to Z88
ready for first file...
<ESC "N"> <FileName1> -> first file(name)
file <FileName1> created,
<ESC "F"> <File> -> receiving file...
<ESC "E"> -> End of File. file closed.
<ESC "N"> <FileName2>
file <FileName2> created.
<ESC "F"> <File> -> receiving file...
<ESC "E"> -> End of File. file closed.
<ESC "Z"> -> End of Files. Last file sent. Command
completed.
------------------------------------------------------------------------------
Â