TIM0-4, $D0-4
Register Period Counts to Width in bits
TIM0 5ms 199 8
TIM1 1 second 59 6
TIM2 1 minute 255 8
TIM3 256 minutes 255 8
TIM4 64K minutes 31 5
The clock is reset to zero by settings RESTIM in the COM register. The clock will be held in reset, ie. it won't count until RESTIM is cleared again. In order to guarantee a valid result from any of these registers, software needs to read until two equal values are returned. This should always occur within three read cycles.
There are three interrupts that the real time clock can generate and these are TICK (200 times a second - 5ms), SEC (once a second) and MIN (once a minute). Three registers are associated with these interrupts:
TSTA ($B5), Timer interrupt status
BIT NAME Function
7 - 3 - -
2 MIN Set if minute interrupt has occurred
1 SEC Set if second interrupt has occurred
0 TICK Set if tick interrupt has occurred
TMK ($B5), Timer interrupt mask
BIT NAME Function
7 - 3 - -
2 MIN Set to enable minute interrupt
1 SEC Set to enable second interrupt
0 TICK Set to enable tick interrupt
TACK ($B4), Timer interrupt acknowledge
BIT NAME Function
7 - 3 - -
2 MIN Set to acknowledge minute interrupt
1 SEC Set to acknowledge second interrupt
0 TICK Set to acknowledge tick interrupt