Page Comparison

RAM Test

Cambridge Computer wrote a BBC BASIC program to test RAM.

Image Added

Unless the memory is good the Z88 will become unstable, the FAIL indicator may appear in the top right-hand corner of the display or inconsistent results will occur when checking the size of the RAM with (<> Image Added CARD). For example, you may have a 512K Ram RAM card in your Z88 but (<> Image Added CARD) reports that you only have 128K. Failure of the RAM falls in into the following categories.

• Mechanical failure - due to the contacts being dirty or from a dry soldered joint
• Unsuitable memory chip - if a different chip is used it may not have the identical specification to the one previously used.

Running the BASIC program while `tapping' the RAM pack may identify a mechanical failure. Finding other errors can be difficult.

The other sort of memory failure is where certain bits of memory suffer amnesia when you are not reading or writing to the memory.

This is like when you are just storing files in the RAM.

This fault can be found with any program, (zCheck, Zip, Unzip (Z88 Forever) or SqueeZ~88 (Rakewell)) that uses checksums on files. To use it you should:-

1. Run the program initially so that the checksums of the files are calculated. If you are using SqueeZ~88 or Zip, squeeze/Zip a load of big files.
2. Turn off the Z88 and leave it alone for about three to five days.
3. Re-run the program to see if the checksums of the files are different or unsqueeze/Unzip all the files again. If they are, then the RAM where the file was stored is faulty.

The following BBC BASIC program tests 32K, 128K 512K and 1MB Ram packsRAM cards.

It is what This is called a destructive Ram Test which means that all RAM Test. All the data that is stored on in the RAM card will be destroyederased.

Download the 4 files zipped, (original instructions, two .CLI files (which do the same thing) and the memory test software from here, and then transfer them to your Z88 with a transfer program. If the CLI file is in an EPROM in slot 3,

Image RemovedImage Added

There are two ways you can use this program.

1. Just running the BBC BASIC program (Ramcard.bas)
2. Before using the program you should save the program to EPROM as "RAMTEST.BAS" and write the following BOOT.CLI to use with it. This will load and run the program automatically after a HARD RESET is given.

#F
|EF
RAMTEST.BAS~E~E
#B
CHAIN
"RAMTEST.BAS"~E

To use the memory test, follow these steps:-

		Load Save onto an EPROM with card the BOOT.CLI and RAMTEST.BAS files.
		Back-up all your files.
		Open the card flap Remove the current RAM card.
		Insert the EPROM card in slot 3
		Do Leaving the card flap open, do a Hard Reset.  Close the card flap The BOOT.CLI program will run, the memory test program programs will be fetched from the EPROM card and then will start to run.
		When you get the Command line type in the number of K the ram RAM card is. E.g. 1024
		Insert the RAM card to be tested in Slot 1.
		Press the ENTER Image Added key until you get the "Testing . . . " message. Whilst this is testing, tap underneath the Z88 where the card is installed to expose any mechanical electrical problems with the card connector and/or any dry solder joints in the card itself.
		When the test is finished,
		Remove the EPROM pack and
		Do another Hard Reset.
		To make sure that the memory is alright, load a large text file into Pipedream and see if you can read the whole file.