Receive File from Z88

Owned by Gunther Strube
May 01, 2012
2 min read

EazyLink Server, V4.4

Request for Z88 File as specified in the command header. Please note that wildcards is allowed, but not recommended since you might get the wrong file if another match is found in the Z88 filing system than expected.

Please note that the current translation status reflects the data sent to Z88. Activating the []L popdown, the default translation is NONE with no line feed conversion, ie. every byte sent the Z88 is unaffected. This is the original state of the PC-LINK II Server popdown.

If you chose to activate one of the translation/conversion commands, every byte sent the Z88 is translated using either the internal ISO/IBM Codepage 865 or an external "translate.dat" translation table.

The translation and line feed conversion status may also have been enabled or disabled using the appropriate request commands (see later). However, this may only be possible using the EazyLink extended protocol (the original PC-LINK II client doesn't support translation nor line feed conversion during transfer using the EazyLink interface). Translation must be performed after the PC-LINK II transfer.

------------------------------------------------------------------------------
Client                    Server                Action
------------------------------------------------------------------------------
<ESC "G">                                       Request for file to be sent
<FileName>                                      from Z88
<ESC "Z">             ->  receiving filename

receiving             <-  <File>                Send file contents...
receiving             <-  <ESC "Z">             End of File
------------------------------------------------------------------------------

web analytics